All questionsDosing and administration: Leqvio (inclisiran), all indications8 questions · 3 sourcesDosingWhat is the recommended dosage of Leqvio?“The recommended dosage of LEQVIO for adults and pediatric patients aged 12 years and older is 284 mg administered as a single subcutaneous injection initially, again at 3 months, and then every 6 months.” (opens the source at this quote in a new tab)CopyFlagHow many Leqvio injections are needed per year?“2 initial doses, then 2 doses a year1” (opens the source at this quote in a new tab)CopyFlagWhat should be done if a Leqvio dose is missed?“If a planned dose is missed by less than 3 months, administer LEQVIO and maintain dosing according to the patient’s original schedule. • If a planned dose is missed by more than 3 months, restart with a new dosing schedule - administer LEQVIO initially, again at 3 months, and then every 6 months.” (opens the source at this quote in a new tab)CopyFlagAdministrationCan patients self-inject Leqvio at home?“LEQVIO should be administered by a healthcare professional.” (opens the source at this quote in a new tab)CopyFlag“LEQVIO is a subcutaneous injection that can be given by any state-certified HCP1” (opens the source at this quote in a new tab)CopyFlagWhere is Leqvio injected?“Inject LEQVIO subcutaneously into the abdomen, upper arm, or thigh. Do not inject in areas of active skin disease or injury, such as sunburns, skin rashes, inflammation, or skin infections.” (opens the source at this quote in a new tab)CopyFlagHow is the Leqvio prefilled syringe injected?“Step 3. Remove needle cap Firmly pull straight to remove the needle cap from the prefilled syringe (see Figure B). You may see a drop of liquid at the end of the needle. This is normal. Do not put the needle cap back on. Throw it away. Note: Do not remove the needle cap until you are ready to inject. Early removal of the needle cap prior to injection can lead to drying of the drug product within the needle, which can result in needle clogging. Step 4. Insert the needle Gently pinch the skin at the injection site and hold the pinch throughout the injection. With the other hand insert the needle into the skin at an angle of approximately 45 degrees as shown (see Figure C). Step 5. Inject Continue to pinch the skin. Slowly press the plunger as far as it will go (see Figure D). This will make sure that a full dose is injected. Note: If you cannot depress the plunger following insertion of the needle, use a new prefilled syringe. Step 6. Complete injection and dispose of the prefilled syringe Remove the prefilled syringe from the injection site. Do not put the needle cap back on. Dispose of the prefilled syringe in an FDA-cleared sharps disposal container right away after use.” (opens the source at this quote in a new tab)CopyFlagNote: The steps are from the Instructions for Use printed with the Prescribing Information, which is intended for healthcare professionals.Does Leqvio require fasting before the injection?“No fasting requirements” (opens the source at this quote in a new tab)CopyFlagPrescribingHow should a specialty pharmacy prescription for Leqvio be written?“Considerations for Writing Specialty Pharmacy Prescriptions for LEQVIO® When you are acquiring LEQVIO through a specialty pharmacy, it is important to ensure that the prescription is written completely and accurately. Your prescription may be rejected if it is incorrectly written. Please see below for some considerations on how you may write the two prescriptions for LEQVIO.” (opens the source at this quote in a new tab)CopyFlag“Dose Type 284 mg/1.5 mL (189 mg/mL) in a single-dose prefilled syringe Quantity 1 Refill 1 Administration • HCP to inject inclisiran subcutaneously into the abdomen, upper arm, or thigh • HCP to administer initially and again at 3 months Dose Type 284 mg/1.5 mL (189 mg/mL) in a single-dose prefilled syringe Quantity 1 Refill 1 Administration • HCP to inject inclisiran subcutaneously into the abdomen, upper arm, or thigh • HCP to administer every 6 months after the first two doses” (opens the source at this quote in a new tab)CopyFlag“Prescription #1: Initial Doses (Day 0 and Day 90) Prescription #2: Maintenance Doses (Every 6 Months After the First 2 Doses)” (opens the source at this quote in a new tab)CopyFlagNote: In the document, the first block of dose type, quantity, refill, and administration is Prescription #1 (initial doses) and the second is Prescription #2 (maintenance doses).