All questionsDosing and administration: Nucala (mepolizumab), all indications4 questions · 1 sourceDosingWhat should be done if a Nucala dose is missed?“6. If a dose is missed, administer a dose as soon as possible. Thereafter, the patient can resume dosing on the usual day of administration. If the next dose is already due, then administer as planned.” (opens the source at this quote in a new tab)CopyFlagNote: The instruction is step 6 of the label's section on the prefilled autoinjector and prefilled syringes.AdministrationWhere is Nucala injected?“NUCALA is for subcutaneous use only, and should be injected into the upper arm, thigh, or abdomen” (opens the source at this quote in a new tab)CopyFlag“3. Administer the subcutaneous injection into the thigh or abdomen, avoiding the 5 cm (approximately 2 inches) around the navel. The upper arm can also be used if a caregiver administers the subcutaneous injection.” (opens the source at this quote in a new tab)CopyFlag“5. Never give injections into areas where the skin is tender, bruised, red, or hard.” (opens the source at this quote in a new tab)CopyFlagNote: The second and third passages are steps for the prefilled autoinjector and prefilled syringes.How long should Nucala sit out before injecting?“1. Remove the prefilled autoinjector or prefilled syringe from the refrigerator and allow it to sit at room temperature for 30 minutes prior to injection. Do not warm NUCALA injection in any other way.” (opens the source at this quote in a new tab)CopyFlagPreparationHow do you reconstitute the Nucala vial?“1. Reconstitute NUCALA for injection in the vial with 1.2 mL of Sterile Water for Injection, USP, preferably using a 2- or 3-mL syringe and a 21-gauge needle. The reconstituted solution will contain a concentration of 100 mg/mL mepolizumab. Do not mix with other medications. 2. Direct the stream of Sterile Water for Injection vertically onto the center of the lyophilized powder, which may have a cake-like appearance. Gently swirl the vial for 10 seconds with a circular motion at 15-second intervals until the powder is dissolved. Note: Do not shake the reconstituted solution during the procedure as this may lead to product foaming or precipitation. Reconstitution is typically complete within 5 minutes after the Sterile Water for Injection has been added, but it may take additional time. 3. If a mechanical reconstitution device (swirler) is used to reconstitute NUCALA for injection, swirl at 450 rpm for no longer than 10 minutes. Alternatively, swirling at 1,000 rpm for no longer than 5 minutes is acceptable.” (opens the source at this quote in a new tab)CopyFlag“4. Visually inspect the reconstituted solution for particulate matter and clarity before use. The solution should be clear to opalescent and colorless to pale yellow or pale brown, essentially particle free. Small air bubbles, however, are expected and acceptable. If particulate matter remains in the solution or if the solution appears cloudy or milky, the solution must not be administered. 5. If the reconstituted solution is not used immediately: • store below 30°C (86°F), • do not freeze, and • discard if not used within 8 hours of reconstitution.” (opens the source at this quote in a new tab)CopyFlagNote: The passages are steps 1 to 5 of the label's reconstitution instructions for the lyophilized powder vial.